Appendix Environmental : Health & Safety
1.
Introduction
The Department of Economics
has compiled the following summary of important issues raised in the University's
Environmental Health and Safety Manual. It is in your interest to
read the summary thoroughly either before or shortly after you commence
employment at the University. If necessary the Environmental
Health and Safety Manual can be accessed in its entirety here.
If you have any queries or require clarification of any matter raised in
this summary, please contact Cherie Millerick, (Departmental
Manager) on 8344 5355.
2.
University Environmental Health and Safety Policy
The University recognises
its obligation to take all reasonable precautions to provide and maintain,
so far as is practicable, an
environment that is safe
and without risks to health for employees, students and visitors.
3.
Definition of Safety
The absence or minimisation
of risk also includes occupational health in the prevention of accidental
exposure to agents which
may cause occupational diseases.
Thus ergonomics, industrial hygiene, toxicology, radiation safety are all
part of The University
of Melbourne's safety programmes.
4.
Implementation of the University's Environmental Health & Safety Policy
To meet its obligations,
the University will take all reasonable steps to:
-
observe and implement relevant
statutory requirements;
-
develop risk management as part
of the culture of the University;
-
promote workplace safety by
education, information and instruction;
-
ensure that adequate instruction
is given to employees and students in safe working procedures and that
they are informed of any hazard to their health which is known to
be associated with work in which they are involved;
-
ensure that situations or work
practices which are unsafe or harmful are reported immediately to the supervisor
of the employee or student, so that corrective action can be taken;
-
encourage each person in the
University to regard accident prevention as an individual responsibility;
-
require the head of each academic
and administrative department to apply the general safety rules of the
University, as appropriate, to the specific needs of the Department in
consultation with staff of the Risk Management Office and local staff;
-
require that every accident
in the University is reported and, where appropriate investigated, and
ensure any action necessary to reduce further risk is implemented;
-
establish procedures to minimise
the risk of harmful effects of fire, explosion, radiation, biological hazards
and chemical release and ensure these procedures are regularly monitored;
-
maintain (in the work place)
proper control of harmful substances (i.e. chemicals, radiation, fire hazards,
biological hazards etc), air pollution and noise;
-
establish procedures for the
evacuation of buildings in the event of fire, explosion or other emergencies
and ensure those procedures are appropriately tested;
-
ensure that machines and equipment
are maintained in safe condition and that necessary personal protective
devices are available in the workplace;
-
provide adequate occupational
health services and monitoring programmes;
-
maintain proper control over
the storage, use and disposal of harmful substances;
-
post clearly visible signs and
notices as required;
-
ensure that adequate professionally
trained staff are available to co-ordinate and supervise the University's
risk management program.
5.
Responsibilities For Safety
Safety is the concern of
everyone; however, certain groups within the University community have
specific responsibilities:
DEANS AND HEADS OF
ACADEMIC AND ADMINISTRATIVE DEPARTMENTS
-
are responsible for ensuring
that activities conducted within areas under their control, comply with
the University's Environmental Health & Safety Policy and relevant
legislation (both State and Federal);
-
are responsible for ensuring
that all risk within their areas of control are identified and where practicable,
removed or controlled with the co-operation of the Risk Management Office
where necessary
-
are responsible for implementing
such safety measures as are approved by Council following recommendation
by the Occupational Health & Safety Committee;
-
are required in association
with appropriate personnel to formulate and promulgate specific safety
rules for activities conducted within areas under their control;
-
are responsible for reporting
and investigating accidents that occur within areas under their control;
-
are responsible for reporting
to the Deputy Vice-Chancellor (Resources) any member of staff, student
or contractor working in their area who, by refusal or neglect, fails to
observe safety requirements.
EMPLOYEES
-
while at work, must take all
the care of which they are capable for their own health and that of other
people who may be affected by their conduct at the workplace;
-
must not willfully or recklessly
interfere with or misuse anything provided in the interests of health and
safety or welfare;
-
must not willfully place at
risk the health or safety of any person in the workplace.
Independent contractors employed
by the University come within the category of employees for the purposes
of this policy.
STUDENTS
-
are responsible for adopting
safe work and study practices;
-
must not willfully place at
risk the health or safety of any other person at the University;
-
must not willfully or recklessly
interfere with or misuse anything provided in the interests of health,
safety or welfare at the University.
VISITORS
Visitors are required to
comply with all instructions given by authorised University staff for the
protection of their health and
safety whilst on University
premises.
6.
Reporting of Accidents and Hazards
Introduction
It is important to recognise
the need for reporting, investigating and analysing all injuries, accidents
and potential hazards. This
section sets out a procedure
for reporting all accidents and potential hazards. Accident investigation
procedure is covered in
section 4.2 of the EH&S
Manual.
Legal Requirement
It is a legal requirement
under Occupational Health & Safety legislation and an insurance requirement
to report all work injuries.
However it should be recognised
that good reporting leads also to effective prevention.
Definitions
Incident -
An unplanned event which may cause injury and/or damage to property and/or
equipment, or has the potential to cause injury or damage.
Work Accident Injury-
Any injury, occupational disease or disability which arises in the course
of any University sponsored activity which requires first-aid or medical
treatment.
Hazard -
Any obstruction, matter or event which has the potential to cause injury
or an accident.
Reporting Accidents
-
The correct form to complete
is a "Form
S3" headed Accident/Incident Report. The form is available
from Faculty or Department offices and may also be obtained from the Stationery
Store.
-
All accidents causing injury
must be reported, including those incurred by students and contractors'
employees. The top part of the form should be completed by the person sustaining
the work injury. If the person sustaining a work injury is not able/available
to complete the form, another person should complete the form as soon as
possible, preferably the same day.
-
Incidents not causing injury
should also be reported. In this case, the person involved in the
incident or supervisor of the area should commence the report.
-
It is important to provide as
much detail as possible, including Employee Number, date of accident/incident
and correct place of incident. This is for recording and computing purposes
and personal details will be treated confidentially. Do not use terms such
as `my office' or `hurt left finger'. Use specific and identifiable building
and room numbers or locations; for injuries, describe the condition suffered
eg. cut left finger or bruised left finger.
-
The Form S3 report must be forwarded
to the Department Head, or nominated Deputy, for investigation and comment.
On completion of this, the form will be forwarded to Risk Management
Office and a copy is retained for departmental records.
Reporting Hazards
-
The prime responsibility for
recognising and removing or safeguarding hazards rests and remains with
each Department and Faculty.
-
Once a hazard, or potential
hazard is recognised, consideration should be given of corrective action
required. Where possible, action should commence from within the Department,
eg cleaning up a chemical spill, removing an obstruction in the passage
etc. If the hazard is considered beyond the Department's resources, maintenance
should be notified, giving details of the location and nature of the hazard.
-
For serious hazards, it is desirable
that the Manager, Risk Management be notified immediately. This can be
done on a Form S3 or an ordinary memo. However, notifying the Risk Management
Office is no substitute for completing an S3 form.
-
Each Department shall set down
in its Departmental procedure who and how Maintenance (phone 8 344 6000)
is to be notified of hazards. The responsibility rests with the Department
Head.
7.
Occupational Health and Policy Statements
Smoking in the Workplace
- October 1989, revised and accepted 1993
Health Promotion Policy
- November 1992
Heat Policy - January
1, 1991
a.
Smoking in the Workplace
"That there be a prohibition
on smoking in all University buildings and vehicles, effective from January
1, 1990".
Staff should note that this
prohibition has been extended to include some outdoor areas. For
details see the smoking
policy contained in the EHS manual.
b. Health
Promotion Policy
In its Mission Statement,
the University recognises its obligation to people "to assist them to develop
their full potential". The objective of this Health Promotion Policy
is to encourage people to achieve their optimum level of health, fitness
and wellbeing. The University will seek to provide appropriate information,
avenues and resources to enable people to achieve that potential.
The Occupational Health and
Safety Act requires an employer to provide a work place that is safe and
without risks to health. The University Occupational Health &
Safety Policy addresses this requirement and details the responsibilities
of the University, Heads of Departments and employees in maintaining
a safe workplace. This Health Promotion Policy is complementary to the
Occupational Health & Safety Policy.
Individuals are responsible
for their own level of health and fitness. The University has an interest
in and provides encouragement for staff and students who participate in
health promotion and fitness programmes.
The aims of this Policy will
be achieved by:
-
The promotion of better understanding
of health issues;
-
The delivery of activities that
lead to an appropriate level of fitness and wellbeing.
The Risk Management Office (RMO)
in conjunction with the Director of Student Health Services has the responsibility
for developing and implementing health and safety awareness programmes.
The mechanisms to be used include Risky Business and University News for
general articles. Targeted programmes will use videos and specific promotional
material.
Melbourne
University Sport (MUS) has the responsibility for designing and implementing programmes
that will encourage staff to participate in activities which will enhance
their wellbeing and health.
Heads of Departments should
consider ways of assisting staff and students in regard to health and safety
promotion.
Advice and resource materials
are available from the Occupational Health Service for health information,
and from MUS on
fitness programmes.
c.
Heat Policy
See EHS Manual.
8.
Issue Resolution Procedures
The following action sequence
is proposed whereby health and safety issues can be resolved in a cooperative
manner:
| 1. |
The elected Health and Safety
Representative identifies a safety issue or problem in his/her designated
work group. Note that the matter may have been referred initially to the
representative by another staff member or Health and Safety Representative
from another work group. |
| 2. |
The Health and Safety Representative
brings the matter to the attention of the supervisor of the work area involved
(eg laboratory manager, workshop foreman) by the use of an S3
Incident Form. |
| 3. |
The representative may have
sought the prior advice of the Risk Management Office (RMO) in doing this.
The supervisor of the work area may also seek advice from the RMO upon
receipt of the S3 form. |
| 4. |
If, within 5 working days
or less, the supervisor and representative can reach agreement on the means
to deal with the concerns raised, the matter is then regarded as satisfactorily
resolved at the local level. Satisfactory resolution would include immediate
settlement of this and any related concerns as well as an agreed plan and
timetable for future action if immediate action is not possible. |
| 5. |
If, however, the representative
and the supervisor cannot satisfactorily resolve the issue at the local
level and the representative believes that the issue should be pursued,
the representative should refer the issue involved to the head of department
responsible for the workplace in question. At this stage, the Health and
Safety Representative should formally advise the RMO. |
| 6. |
The Head of Department,
representative and a member of RMO then engage in an attempt to reach agreement
in a satisfactory resolution of the issue within 5 working days. If the
head of department is not able to take part, for some reason, (and
this would be seen as an exceptional instance) an appropriate nominee with
the delegated authority to commit the department to any consequential undertaking
may be nominated. Again, satisfactory resolution includes immediate settlement
or an agreed plan of future action. |
| 7. |
If no satisfactory resolution
can be reached at step 5 that resolves the issue, then the Health and Safety
Representative should further investigate the issuance of a formal Provisional
Improvement Notice. |
These procedures should be
read and understood to comply with the requirements of the Occupational
Health and Safety Act and in no way override the rights and obligations
of elected Health and Safety Representatives under the relevant legislation.
9.
Immediate Safety Hazards
Using the steps outlined
above, the majority of safety issues should be capable of immediate and
preferably local resolution using line management and stopping at stage
3.
However, there may be circumstances
where a definite and immediate safety hazard is perceived, and the issue
is considered urgent and serious. In this case, the Health and Safety Representatives
will inform the supervisor of the area who should call an immediate halt
to the work whilst the issue is investigated.
In the event the supervisor
fails to agree about the degree of risk present or the supervisor is not
available, the Health and Safety Representative will direct affected employees
to withdraw from the alleged hazard having regard to the health and safety
of others and will then inform the appropriate manager of the actions that
have been taken pending a full investigation. The Health and Safety Representative
will immediately inform the RMO of the action taken and the sequence of
events listed above will start at stage 4.
Work will not resume until
it has been agreed that the hazard has been controlled and no longer presents
an unacceptable risk to the safety and health of employees. Alternative
duties may be found for those members of staff affected, but no pay will
be lost in the event of a demonstrated safety hazard having been detected.
A written report of the situation
and the actions taken should be prepared by the Area Supervisor, and where
appropriate the Health and Safety Representative, for the Occupational
Health and Safety Committee and the Risk Management Office.
Identified hazards should
be controlled using the recognised hierarchy of controls:
-
Elimination
-
Substitution
-
Isolation
-
Engineering controls
-
Safe work practices
-
Personal Protective Equipment
and Clothing
For further information on hierarchy
of controls, see Section 4.2 of the Environmental
Health and Safety Manual.
For other relevant information,see Risk Management Web Page
|